top of page
Delicate Fabric

- Lesson 5 -

EXPERIMENT PRINTING  

PRUSA MK4

image_edited.jpg

In the last session, my group and I tested out bridge 3D printing with Ultimaker. Now, we trying it with Prusa, which is actually faster, and I find the Prusa software easier to use.

image.png

MARVIN (PRUSA VS ULTIMAKER)

image.png

Ultimaker (12 minutes)

image.png

Prusa (6 minutes)

In the same setting, Prusa takes 6 minutes to print, while Ultimaker takes 12 minutes. Overall, Prusa is actually the fastest among them.

image.png
image.png

Prusa (left), Ultimaker (right) before removing support and brim

Prusa (left), Ultimaker (right) after removing support and brim

TESTING OUT DIFFERENT INFILL

Grid infill

image_edited.jpg
image.png

Concentric infill

image.png
image_edited.jpg

Lightning infill

image.png
image.png

Lightning and concentric infill results in a faster print time of 23 minutes while using grid infill increases the printing time slightly to 24 minutes.

© 2024 by Chuan Teck Suan Powered and secured by Wix

bottom of page